Apex Dual Orin RS422/485 Usage

Hardware Specification

Function Label

Pin Label

Function and Device Node

Function	Description	Device Node
M_UART(485)A	Master Orin 422/485 A	/dev/ttyUART_422_485_A
M_UART(485)B	Master Orin 422/485 B	/dev/ttyUART_422_485_B
S_UART(485)A	Slave Orin 422/485 A	/dev/ttyUART_422_485_A
S_UART(485)B	Slave Orin 422/485 B	/dev/ttyUART_422_485_B

Usage

Preparation

PC（Ubuntu System）

#Install
sudo apt-get install putty -y

Device

#install
sudo apt-get install putty -y

Receive-Send Test

Device

#Open putty
sudo putty

After opening Putty, configure the parameters in “Session”. Enter the device node in “Serial line” and set the speed to 115200 in “Speed”. Choose “Serial” in “Connection type”.

Configure the parameters in “Terminal”, select “Force on” in “Line discipline options”, and then click “Open” to enter the data transfer interface.

PC

Obtaining the UART device node on the PC side.

#After connecting the USB to serial module to the PC side, execute the command, and the output result is the UART device node.
 ls /dev | grep -E 'ttyUSB[0-9]+' | sort -V | tail -n 1

#Open putty
sudo putty

After opening Putty, configure the parameters in “Session”. Enter the device node in “Serial line” and set the speed to 115200 in “Speed”. Choose “Serial” in “Connection type”.

Configure the parameters in “Terminal”, select “Force on” in “Line discipline options”, and then click “Open” to enter the data transfer interface.

Use PuTTY to determine whether the send and receive operations are successful.

Observe the transmission interfaces on both the device side and the PC side. Enter any information in either interface, and if both interfaces display the same content, it means that the send and receive operations are successful.

PC

Device