Apex Dual Orin 5G Usage

Usage

5G module can be used only on Mater Orin.

5G module and SIM card Installation

Remove the bottom panel:

Antennas:

Installation Steps:

1.Install the 5G module on the M.2 B mount shown in the M drawing with 1 M3*8 Phillips with adhesive screws

2.Attach the two antenna adapter cables, IPEX connector snap on the 5G module, and the SMA female connector to the antenna connector of the device

3.Attach the thermal pad on the 5G module, thickness: 4mm.

4.Install the SIM card on the SIM holder.

5.Attach the antenna to the antenna connector of the device

Reference Photos：

Required accessories:

• 5G Module(M.2 B Key)x1

• SIM card x1

• M3*8 Phillips screws with adhesive x1

• IPEX to SMA antenna adapter x2

• 4mm thermal conductive sheet x1

Notes：

• 5G module requires thermal pads for heat dissipation

Auto-start settings at boot

Built-in driver does not require any additional configuration. It starts automatically and dials automatically when it is turned on.

Module configuration method

Please note that if you are using an IoT SIM card, there will be issues with binding the SIM card to the device hardware. Please confirm with your communications provider in advance.

System image integrates the corresponding module driver. After the module is installed, the system will automatically recognize it.

M.2 B Key 5G Support List

NO.	Brand	Product NO.	Interface	Module function	Operating temperature	Spec	Note
1	Quectel	RM500Q-CN	M.2 B KEY	5G	-20ºC - 60ºC	SA : DL: 2.1Gbps ； UL:900Mbps NSA : DL: 2.5Gbps ； UL:650Mbps